Pentruder

RS2 and some sparks, does it get any better than this? The two RS2 were purchased by TrueCut Diamond Drilling in England specifically for the job that is in UK House on Oxford Street, in Londons West End. The project involves removing the plant rooms buildings Mansard rooves and the lightwell upstand walls, along with staircases and lift motor rooms and overuns to enable the building of a new Penthouse. Over a mile (1600 m) of cutting into sections and lifting into skips. Colin Walker, MD at Truecut.

While some of us have been in sunny Las Vegas at #worldofconcrete, others have been working hard in the cold. Good job guys and thanx for sharing!

Wall sawing and core drilling for Friday. Two sections completed in one day, nice piece of work. @walkercuttingservices @pentruder_official @icsdiamondtools @ic...smike @k2_diamond #wallsawing #coredrilling #SDVOB #veteranowned @csdaconcrete #csdacertifiedcompany #csdacertifiedoperator #laborerslocal172 #concretesawing #concretecoring #concrete See more

Pentruder UK at their best On site at JKI Limited handing over their new Pentruder 8-20IQ. Congratulations to the team on your latest purchase. #wallsaw #pentruder #concretecutting

The RS2 with the new GFRS flush cutting blade guard in action.

Entregando una nueva RS2

Pentruder UK has started with their demos for the Pentruder RS2 and gave it a proper challenge the other day. We were cutting in one the most hardest aggregates in the UK, over 40MPA which they deliberately set the track over steel to run down the bar as they felt this to be a good test for the machine. - Graham Crewe, Pentruder UK

The Pentruder RS2 HFi Wall saw is just a easy to set up as the older Pentruder HF models. You can use the same track to your RS2 as you do to your HF Wall saws. The biggest difference in the setup is that the RS2 has only one connector and cable between the saw head and the Pentpak 3. Have a look at these two videos to learn more. NOTE! These short videos can never replace reading the Operator manual, always read it before using the machine and always follow all safety instructions in the Operator manual. https://youtu.be/KSdwU6GbdnM

CUSTOMER: Can you do it? B & D: Here, hold my...uh...water! (Contributor: Josh Parker)... Our customer had a concrete wheel-stop that was poured too high and the back of their trailers kept hitting and chipping the concrete. To prevent this they requested a 45 degree angle cut off the back edge. We used a Pentruder wall saw with a 60" blade, L-brackets, and adjustable boots for cutting angles. Took a few minutes to set up, but the results speak for themselves. Operators were William "Red" Crews and Reonard "Nard" Hall. Impressive!

Då var veckans sista jobb avklarat. Fyra stallfönster i sparstensvägg sågade och lyfthål borrade. På det vackra Österlen för @hantverkarnasyd. Nu håller vi hel...g. #pentruder #väggsågning #österlen #betonghåltagning #betongsågning #kärnborrning

The RS2 with the new GFRS flush cutting blade guard in action.

Då var veckans sista jobb avklarat. Fyra stallfönster i sparstensvägg sågade och lyfthål borrade. På det vackra Österlen för @hantverkarnasyd. Nu håller vi hel...g. #pentruder #väggsågning #österlen #betonghåltagning #betongsågning #kärnborrning